M136 Valve adjustment special tool

[Marc1340]

Hello Gentlemans

At this time I've dismantled my 170S 1950 engine and prepare it
I see the admission valve cylinder number 3 seem not working so good , (the valve still open and not going down , if you push it by hand its ok ..)
So I want to replace all the cylinder 3 staff admission and exhaust ( valve-spring-cone -tappet-ring etc )
On waiting of the parts , I began the adjusting of valves
On the repair manual , they talk about one special tool nammed Wst 1198 = "Holding wedge for the valves tappet for valve adjustment"
The repair manual show it at the tool part as a very simple tool ( plate ) but I don't understand how they use it
With all the 170 owner here, I supposed that someone had that tool or use another one .
Please can someone show me with a picture or a drawing of what kind of "special tool" is ??
I began the job with 3 forks plate key 14 mm but its not so easy
I'm sorry but it's my first M136 engine I had on my old hands !!
Thanks a lot
Friendly
Marc

[Marc1340]

Hello Gentleman


Just for close that subject , if it can help somebody :

Outils soupapes_Page_1.jpg (10.7 KiB) 4357 mal betrachtet

Outils soupapes_Page_2.jpg (11.72 KiB) 4357 mal betrachtet

Outils soupapes_Page_3.jpg (13.4 KiB) 4357 mal betrachtet

[Marc1340]

Outils soupapes_Page_4.jpg (11.85 KiB) 4357 mal betrachtet

Outils soupapes_Page_5.jpg (8.57 KiB) 4357 mal betrachtet

[Marc1340]

Hallo
Sorry but its seem that the quality of my pictures loose quality during the transfeert on the website.
I try but pdf format , could be better
Thanks a lot

Outils soupapes.pdf

(1.04 MiB) 257-mal heruntergeladen

[WilliD]

Hallo Marc- ein Bild, später kommt noch ein Bild. Gruß Willi

Ventile 1.jpg (1.28 MiB) 4302 mal betrachtet

[WilliD]

Hallo Marc-next stepp Gruß Willi

[Marc1340]

Hello Willi

Many thanks for your informations and your pictures

You’ve the good tools !!

Best regards
Marc